水星MW300R TTL刷800N后备份系统配置再回复后三个灯一直亮

[复制链接]

那个男人

3458 回帖	6361 积分	4505 小时在线时间

中校

点评砖家

注册时间: 2012-10-26

金币: 1970 个

威望: 16 个

荣誉: 5 个

发消息

累计签到：75 天
连续签到：1 天
[LV.100]试剑无线

发表于 2013-11-22 23:25

水星MW300R TTL刷800N后备份系统配置再回复后三个灯一直亮
没有恢复备份之前没有这个问题
试过从新刷一次还是一样的问题
有点奇怪，刷之前cpu是500m的刷完之后cpu变成了535M

求解决办法，附上刷机信息

      ________  ________          __    __  ____ _  __ ___
      |________|| ___  |          |  | |  || \ | ||  | /  /
         |  | |  |___| | __ __ |  | |  ||    \| ||  |/  /
         |  | | _____|  |__ __|  |  |___ |  || |\    ||    \
         |__| |__|                |______||__||_| \____||__|\___\

                        Software Platform for MIPS
Creation date: Nov  8 2011, 17:46:50 (huangqingjia@tp-link.net)
Copyright(C) 2001-2012 by TP-LINK TECHNOLOGIES CO., LTD.
CPU: AR9341: AP123 Board
CPU freq: 535 MHZ
SDRAM size: 16 MB
ipaddr:192.168.1.1
serverip:192.168.1.100
file:vxWorks.img

Press Ctrl+C to stop auto-boot...
0
auto-booting...
Uncompressing...done
Starting at 0x80001000...

Attaching interface lo0... done
Rx clbufs 2048 each of size 1756
eth_rx_netpool_init: allocated, pDmaBuf=0x80b80320, buffend = 80ef2324
ATHRS27: resetting s27
ATHRS27: s27 reset done
eth_rx_netpool_init: done already!
enet1 port2 up
LAN Port Interface type is 0x4c04
Attached IPv4 interface to mirror unit 0
usrAppInitEx: 122: GPIO_OE = 71300
usrAppInitEx: 123: CP0 CONFIG = 80208483
usrAppInitEx: 124: CP0 CONFIG1 = bee3519e

-->starting wireless...
APCFG task id 809c1810
sysWlanInit ...
Create WLAN event task tWLANEventTask
Create mem partion 0x8099ffe0 for size 86016
AH_CAL_IN_FLASH_AHB
Boostrap clock 25MHz
ar9300RadioAttach: Need analog access recipe!!
Restoring Cal data from Flash
ath_get_caps[4716] rx chainmask mismatch actual 3 sc_chainmak 0
ath_get_caps[4691] tx chainmask mismatch actual 3 sc_chainmak 0
Create OS_MESGQ Successfully at 0x80981ff0
osifp->queue_head = 0x809822f0
ag7240MemInit: allocated, dmabuf=0x8068e5d0, buffend = 809507d4
Entering Task Loop
Entering WLAN event Task Loop
-->wps is shutdown!
ERROR:wireless OR ACL disable
sending message 80664450,24
sending message 80664450,24
TDDP: Now listening client request.
tddp is running.
LAN Port Interface type is 0x4c04

                        Software Platform for MIPS
  Copyright(C) 2001-2010 by TP-LINK TECHNOLOGIES CO., LTD.
  Creation date: Dec 12 2012, 15:41:50
# Starting WLAN !!!!
AP_STARTMODE=standard
AP_ENABLE=1
ATH_COUNTRYCODE=156
wlan_vap_create : enter. devhandle=0x8041c730, opmode=IEEE80211_M_HOSTAP, flags=0x1
wlan_vap_create : exit. devhandle=0x8041c730, opmode=IEEE80211_M_HOSTAP, flags=0x1.
osif_ioctl_create_vap: vap 0x80ffe970 vap->iv_unit 0
ieee80211_end_load: load done
ath0 end flag = 0x00028802
default
default
default
IEE80211-FREQ IOCTL vap 0x80ffe970 0,0,0
AP_CHMODE=11NGHT40PLUS
wantypeDetection
Daemon() in Wantype
WLAN IOCTL .c
AP_CHMODE=11NGHT40PLUS=11NGHT20=11NGHT40PLUS=1003
IEE80211-MODE IOCTL 1,11NGHT40PLUS,13
set mode 11,-2130709132,6
set mode retv 0

WLAN IOCTL AP_PRIMARY_CH=auto=6=auto=1002
IEE80211-FREQ IOCTL vap 0x80ffe970 0,0,11

WLAN IOCTL PUREG=0=0=0=1004
IEEE80211-SETPURGE IOCTL 0

WLAN IOCTL AP_HIDE_SSID=0=0=0=1005
IEEE80211-SETHIDESSIDIOCTL 0

WLAN IOCTL AP_ISOLATION=0=0=0=1034
IEE80211-setparam-nobridge 0

WLAN IOCTL AP_TX11NRATE==0x0=0x0=1041
set auto rate

WLAN IOCTL AP_11G_PROTECTION==0=0=1042

WLAN IOCTL AP_BEACON_INTERVAL=100=100=100=1043

WLAN IOCTL AP_FRAGMENT_THRESHOLD=2346=2346=2346=1044

WLAN IOCTL AP_RTS_THRESHOLD=2346=2347=2346=1046

WLAN IOCTL AP_DTIM_PERIOD=1=1=1=1045

WLAN IOCTL AP_WMM_ENABLE=1=1=1=1051
ieee80211_vap_wme_set

WLAN IOCTL AP_WMM_NOACK==0=0=1052
IOCTL set wmm noack 0

WLAN IOCTL AP_CYPHER_2==CCMP=CCMP=1000
Get EIOCGADDR

WLAN IOCTL AP_NO_EDGE_CH==0=0=1056

WLAN IOCTL AP_MCASTRATE==0=0=1018

WLAN IOCTL AP_MACFILTER_MODE==0=0=1038

WLAN IOCTL AP_MACFILTER_LIST====1000
Get EIOCGADDR

WLAN IOCTL AP_SHORT_GI=1=1=1=1055

WLAN IOCTL AP_DISABLECOEXT=1=0=1=1075

WLAN IOCTL AP_SSID=TP-LINK_E01D68=Ath_AP123ng=TP-LINK_E01D68=1001
IEE80211-ESSID IOCTL 1,TP-LINK_E01D68,15
AP_CHMODE=11NGHT40PLUS
AP_CWMMODE=1
IEE80211-CWMMODE IOCTL 1
AP_AMPDU=0
AP_PURE_N=0
AP_TX_CHAINMASK=1
AP_RX_CHAINMASK=1
AP_SECMODE=None
WPS_ENABLE=0
Security Mode: None
IEE80211-setparam-authmode 1
AP_MACFILTER_MODE=0
ieee80211_open

WLAN IOCTL AP_BASICRATES====1039

WLAN IOCTL AP_DEBUG=0==0=1062

WLAN IOCTL AP_TX_POWER====1073
Starting Hostapd
AP_SSID=TP-LINK_E01D68
AP_HOSTAPD_DEBUG=
AP_IPADDR=192.168.1.2
AP_SECMODE=None
WPS BSS init
WPS_ENABLE=0
AP_SECMODE=None
WPS OPEN BSS init
Adding ath0 in bridge ...
default
Set EIOCGMIB2
default